Skip to content Skip to sidebar Skip to footer

Widget HTML #1

Isuzu 2.6 Head Bolt Torque

Isuzu 2.6 Head Bolt Torque. The first torque spec for isuzu 2.6 exhaust manifold in 58 ft lb. 41 n⋅m (30 lb ft) 6.

Isuzu Troque Specificiations
Isuzu Troque Specificiations from www.webautorepair.org

Final tighten all bolts an additional 90 to 100 degrees recheck final torque in sequence *** caution ***engine uses torque to yield head bolts (tty) that permanently stretch during the initial installation. Cylinder head torque settings 1990 2.6l isuzu motor. Need suggestions for 2 procedures that i am unclear of.

7 3 1 5 9 8 4 2 6 10 First Torque Value Is 58 Ft Lbs.then Final Torgue Is 72 Ft Lbs.


Had the head checked and valve job done. First torque to 58 ft lb. 8 4 2 6 10.

I Just Finished Installation Of My 2.6 Head After A Blown Gasket.


Do not apply engine oil to the crank case side bolts. Tighten the bolts in sequence as follows: Need suggestions for 2 procedures that i am unclear of.

New Cylinder Head Bolts Coated With A Sealant (Such As Gm 1052080).


First torque value is 58 ft lbs.then final torgue is 72 ft lbs. 156 cu in / 2559cc ohc fuel system type: Torque in sequence to 51 ft/lbs step 2:

Final Tighten All Bolts An Additional 90 To 100 Degrees Recheck Final Torque In Sequence *** Caution ***Engine Uses Torque To Yield Head Bolts (Tty) That Permanently Stretch During The Initial Installation.


The first torque spec for isuzu 2.6 exhaust manifold in 58 ft lb. Cylinder head torque settings 1990 2.6l isuzu motor. Cylinder head torque settings 1990 2.6l isuzu motor.

Posted On Mar 21, 2009


Cylinder head bolts for isuzu engines. This is facing the engine. From front to back is this:

Post a Comment for "Isuzu 2.6 Head Bolt Torque"