2004 Chevy Colorado Driver Window And Door Locks Not Working

2004 Chevy Colorado Driver Window And Door Locks Not Working. Leave cables connected for at least 5 minutes 4. Mirror, window, and door lock switch replacement removal procedure remove the 2 screws securing the switch plate assembly to the door trim panel.

My Dad Has An 04' Colorado. Recently The Driver Side Power Window Stopped Along With The Power Locks. The Locks Will Not from www.justanswer.com

Average failure mileage is 66,450 miles. I checked the lock and it says lock 1 which is supposed to unlock both. Every mechanical or electrical problem in your car has a root cause, and the power door lock is no exception.

Source: www.youtube.com

Causes of power door lock not working drivers side. The possible causes could be as a result of fault actuator, frequent use.

Source: www.justanswer.com

I have a 2004 colorado. The key fob remote and switches for door locks do not work.

Source: www.coloradofans.com

Battery terminal, and that did nothing. I started looking on the net and at different forums and found similar problems.

Source: www.coloradofans.com

Disconnect the window and lock controller in the driver's side door. Causes of power door lock not working drivers side.

Source: www.355nation.net

I disconnected the negative battery terminal for cleaning and when i reconnected it, i found that my driver's side power window (but not the passenger side) and both power door locks did not work. Passenger power door lock on 2004 colorado does not work.

Source: www.youtube.com

Leave cables connected for at least 5 minutes 4. I checked the lock and it says lock 1 which is supposed to unlock both.

Source: www.youtube.com

Battery terminal, and that did nothing. Check the battery in the.

Source: www.youtube.com

Lift the front of the switch plate up to disengage clip. Power door locks and drivers window have failed on 2004 colorado.

Source: www.youtube.com

It also only locks the drivers door when put in drive. 1 disconnect the battery for overnight reconnect and hopefully it works again 2 has your battery light been on if so you might want have your battery tested 3 if its your battery, replace it disconnect overnight again and reconnect again 4.

Source: www.justanswer.com

Every mechanical or electrical problem in your car has a root cause, and the power door lock is no exception. 04 colorado door lock problem.

Source: www.justanswer.com

The 2004 chevrolet colorado has 7 problems reported for power window switch stopped working. Average failure mileage is 66,450 miles.

Disconnect The Window And Lock Controller In The Driver's Side Door.

Disconnect the battery and connect both the positive and negative cables together (after disconnected)) 2. I have a 2004 colorado. Battery terminal, and that did nothing.

Causes Of Power Door Lock Not Working Drivers Side.

I have a 2004 colorado crew cab, the windows work but the power locks only work on the drivers door and not the other three. Mirror, window, and door lock switch replacement removal procedure remove the 2 screws securing the switch plate assembly to the door trim panel. I checked the lock and it says lock 1 which is supposed to unlock both.

04 Colorado Door Lock Problem.

Leave cables connected for at least 5 minutes 4. Look at diagram 3, the one line that branches off from the center of the page near the bottom is the child lock wire, so , at the drivers switch on the front door, make sure there is power present at the dark blue wire when the child lock is not active and then make sure there is no power when the child lock is active, if either of those dont. Posted by anonymous on mar 30, 2013.

Disconnect The Electrical Connectors (3, 4) From The Switches (2, 5).

I have a 2004 colorado 4x4 ext cab 5cyl z71. Read more bobbyss automotive repair/damage. Passenger power door lock on 2004 colorado does not work.

It Is Acting Like It Is In Lock 3.

I disconnected the negative battery terminal for cleaning and when i reconnected it, i found that my driver's side power window (but not the passenger side) and both power door locks did not work. Ok first the.door lock problem, with the drivers door closed the drivers door switch locks and unlocks all doors. Remove the switch plate out of the door trim panel opening.